Estimated reading time:3 minutes, 8 seconds
Looking for answers to the “how to replace my windows?” question? Then you have come to the right place. Most homeowners have seen professional Windows installations and wondered whether they can do it.
Essentially, a high-quality window will eliminate the need to get storm windows. However, you might still need to get screens. Irrespective of your choice of window, there are some things you need to know.
In the following sections, we will provide you with the necessary process of replacing windows. So much time as you get the right products and panes, you should be able to complete the project on your own and finally, get the answers to your “how to replace my windows?” question.
MATERIALS AND TOOLS
– Utility Knife
– Replacement Window
The cost of these products and their availability may vary by market or online. So, let’s get down to the process of replacing your windows on your own:
Measure the New Window
While installing a new window, you need to get accurate measures for each window. This way, your windows will fit perfectly for easier installation and maximum energy savings.
As far as possible, ensure that you take all measurements from inside the house. Use small measures to make sure that the new replacement window will perfectly fit into your window frame.
To find the width, therefore, measure from inside the jamb from one end to the other. Also, measure at the middle, top and bottom of the window. For the height, take your measurements from the top of the sill down to the lower part of the head jamb. Then, measure at the right, middle, and left of the window.
Remove Old Window Sashes
To ensure the replacement windows will fit in your existing frame, remove the inside stop, parting bead and the sashes. Remove the inner stop pieces, taking care because you will need them to install your new windows.
Then, remove the inside sash and slide the outer sash to the bottom. Next, remove and get rid of the parting beads. However, leave the exterior stop from the jambs because you will need them to retain your replacement window.
Clean the sill and jambs thoroughly and fill any holes with caulk.
Installing Your New Window
Poorly adjusted or installed windows waste copious amounts of energy. They are also difficult to operate. Therefore, you need to be careful as you install and adjust your new window. Where possible, invest in energy-efficient windows.
Start by laying a bead of caulk on the inside of the outer jamb stops. Mark the sill to get the sill angle and caulk/install the sill angle.
Center the bottom and top sashes vertically within the new frame. Then, slide the bumper stops right towards the center of the frame so that you can see the four mounting holes in the side jambs.
Place the expander/header on top of your window and caulk the top. Next, place your window in the opening and confirm it is square. After that, install the mounting screws at the bottom and top of each side jamb.
You should then slide the header up to ensure all gaps are sealed. Check for smooth operation and correct any problems you encounter. Finish by caulking the inside of the new window and reinstall your inside stops.
As you can see, the above answers the question of “how to replace my windows?’ easily. You should, therefore, be able to handle the window replacement on your own. However, if you have any problem, consider calling us to help you out. We have the window replacement expertise you need in such cases, and we look forward to working on your project.